The table below the recommended brand and specifications.
Ambient Temperature
Shell Oil
Mobile Oil
ESSO Oil
BP Oil
TOTAL Oil
Caltex Oil
Gulf Oil
CPC Oil
-15~0°C
(-5~-32)°F
Mobilgear
626
Energol
GR-XP 46
GR-XP 68
GR-XP 100
CARTER EP
68, 100
Meropa
Lubricant
68
0~35°C
(32~95)°F
Omala Oil
150, *220
Mobilgear
629, *630
Spartan
EP 150
*EP 220
Energol
GR-XP 150
GR-XP 220
CARTER EP
150, 220
Meropa
Lubricant
150, *220
EP Lubricant
HD150
*HD220
CPC
HD150
HD220
35~50°C
(95~122)°F
Omala Oil
320, 460
Mobilgear
632, 634
Spartan
EP 320
EP 460
Energol
GR-XP 320
GR-XP 460
CARTER EP
320, 460
Meropa
Lubricant
320,*460
EP Lubricant
HD320
HD460
CPC
HD320
HD460
Relatively high ambient temperature in summer, or the occasion, the use of higher viscosity oil.
Confirming and checking the oil before operation.
To altering the oil after 300 hours on the primary turning, then altering the oil after 1000 hours per times.
Take off the Oil-Level bolt when the oil are filled, Over-flow from the oil-level bolt then screw in bolt and stand for some minutes, repeat filling so that the oil sure are not overflow from the oil level bolt.
Low noise will occur when the oil no enough in the reducer, please filling the oil again.
Coating the pipe thread sealing tape on the all bolts when screwing.
If have the oil flow from the breather bolt during the turning,
Then take off the oil-level bolt so that the oil flow from it at "Start" condition.
ROLADRIVE®Installation
The revolving direction of exporting and importing are inverse and allow to running on the different direction.
Don't have to install the thrust bearing in the reducer, if need it, contact us please.
Horizontal type reducer to install, incline angle don't over 15 degree, vertical type reducer to install, low speed shaft toward down, other necessary installation type, contact us, please.
The transmission elements are pressed in the shaft which need to use the bolts, avoid to knock.
Confirm to the normal ventilation before running.
Control to use the inverter, the frequency don't setting below 15HZ for avoid the vibration of the motor.
Confirm to the voltage, frequency and phase of the power unit, refer to the line connecting diagram in the motor cover.
Adopting the coupling must to consider the center line and sure accuracy.
Use the transmission belt, need to note the parallelism and the tension don't over, avoid bearing to damage.
