Inch Shaft Reducer
ROLADRIVE ® Lubricating oil recommended
The table below the recommended brand and specifications.
Ambient Temperature
Shell Oil

Mobile Oil

ESSO Oil

BP Oil

TOTAL Oil

Caltex Oil

Gulf Oil

CPC Oil
-15~0°C
(-5~-32)°F
  Mobilgear
626
  Energol
GR-XP 46
GR-XP 68
GR-XP 100
CARTER EP
68, 100
Meropa
Lubricant
68
   
0~35°C
(32~95)°F
Omala Oil
150, *220
Mobilgear
629, *630
Spartan
EP 150
*EP 220
Energol
GR-XP 150
GR-XP 220
CARTER EP
150, 220
Meropa
Lubricant
150, *220
EP Lubricant
HD150
*HD220
CPC
HD150
HD220
35~50°C
(95~122)°F
Omala Oil
320, 460
Mobilgear
632, 634
Spartan
EP 320
EP 460
Energol
GR-XP 320
GR-XP 460
CARTER EP
320, 460
Meropa
Lubricant
320,*460
EP Lubricant
HD320
HD460
CPC
HD320
HD460
Relatively high ambient temperature in summer, or the occasion, the use of higher viscosity oil.
Confirming and checking the oil before operation.
Take off the Oil-Level bolt when the oil are filled, Over-flow from the oil-level bolt then screw in bolt and stand for some minutes, repeat filling so that the oil sure are not overflow from the oil level bolt.
Low noise will occur when the oil no enough in the reducer, please filling the oil again.
Coating the pipe thread sealing tape on the all bolts when screwing.
If have the oil flow from the breather bolt during the turning,
Then take off the oil-level bolt so that the oil flow from it at "Start" condition.
ROLADRIVE ® Installation
The revolving direction of exporting and importing are inverse and allow to running on the different direction.
Horizontal type reducer to install, incline angle don't over 15 degree, vertical type reducer to install,
low speed shaft toward down, other necessary installation type, contact us, please.
The transmission elements are pressed in the shaft which need to use the bolts, avoid to knock.
Confirm to the normal ventilation before running.
Control to use the inverter, the frequency don't setting below 15HZ for avoid the vibration of the motor.
Confirm to the voltage, frequency and phase of the power unit, refer to the line connecting diagram in the motor cover.
Adopting the coupling must to consider the center line and sure accuracy.
Use the transmission belt, need to note the parallelism and the tension don't over, avoid bearing to damage.
ROLADRIVE ® Disassembly Dwg.
1. Oil Bushing
2. Output Shaft
3. Oil Seal
4. Shaft Pin
5. Sleeve
6. Inner Roller
7. Spacer
8. Roller Disc
9. Inner Roller
10. Needle Pin
11. Outer Roller
12. Elastic Aaxis
13. Coupling Kit
14. Hollow Joint
15. Needle Casing
16. Eccentric Bearing
17. Roller Disc
 
 
 


 
KOTEC PRECISION MACHINERY, INC.
TEL: +886-4-2688 8550   FAX: +886-4-2688 8547
No.312, Sec. 1, Zhongshan Rd., Dajia Dist., Taichung City 437, Taiwan.
Copyright© 2019   KOTEC Precision Machinery, Inc. All rights reserved